Bergstrom DUAL POWER II Instrucciones De Montaje página 25

DUAL POWER II
INSTALLATION OF POWER SUPPLY AND RELAY EXCITATION CABLE
1- Connect the power supply cables to the
compressor-condenser unit, and run to the
battery with the original cables. Connect
cable Az (+) and M (-).
Caution: (2) standard length cables included,
cut to the required length and secure the
terminals.
2- Connect the excitation cable to the unit, and
run it to the (+) or the starter motor through
the ignition key. Cut cable to the required
length and secure the terminals.
3- Secure the cables with ties.
1
2
2
1
3
25
EN