Virutex FRB300 Manual De Instrucciones página 21

contact from one terminal to the other. Shorting the
battery terminals may cause burns or a fire.
• Battery fluid may be spilled under extreme conditions;
avoid contact with this liquid. In case of accidental
contact, rinse thoroughly with water. If the liquid comes
into contact with your eyes, seek medical attention.
Battery fluid may cause irritation or burns.
• Do not use damaged or modified batteries. Damaged
or modified batteries can behave in an unpredictable
way and may cause injury to the operator and a fire risk.
• Avoid switching the device on accidentally. Make sure
the on/off switch is in the off position before inserting
the battery. Carrying the power tool with your finger
on the on/off switch or inserting the battery with the
switch in the on position can cause accidents.
• Do not open the batteries. You could damage the
circuits.
• Fumes may be aired if there is battery damage and
improper use. In this case, go to a well-ventilated location
and seek medical assistance, if necessary. Fumes cause
respiratory irritation.
• When the battery is defective, the liquid may leak and
come into contact with adjacent components. Check the
corresponding parts. Clean or replace them, if necessary.
• Protect the battery from heat, continued solar radiation
and fire. There is an explosion hazard.
Read all instructions and safety warnings.
• Protect the battery charger from rain and moisture.
Water entering the charger increases the risk of electric
shock.
• Do not charge other batteries. The battery charger is
only suitable for charging lithium-ion batteries within
the indicated voltage range. Otherwise, there is a fire
and explosion hazard.
• Keep the battery charger clean. Dirt can cause a risk
of electric shock.
• Always check the battery charger, its cable and plug
before using them. Do not use the charger if you see it
is damaged. Do not open the charger on your own. Have
it repaired by a qualified person who uses original spare
parts. Damaged chargers, cables and plugs increase the
risk of electric shocks.
• Do not use the battery charger on highly flammable
surfaces. For example, paper, textiles, etc., or in
combustible environments. A fire hazard exists from the
charger heating during the charging cycle.
2. SPECIFICATIONS
Battery voltage........................................................20 V
No-load speed..................................10,000 - 30,000 min
Battery type....................................................................Li-Ion
Time to charge battery....................................60 min
Battery capacity.....................................................2 or 4 A
Collet chuck capacity...................................6 mm
Net weight...........................................................................2 kg
Weighted equivalent continuous acoustic
pressure level A...........................................................87 dBA
Acoustic power level A............................................98,5 dBA
Wear ear protection!
Vibration total values.........................................a
Uncertainty..........................................................K: 1,5 m/s
Power tool designation
The tool is intended for flush trimming and profiling of
wood, plastic and similar materials.
3. COMPONENTS
1. Cordless palm router
2. Ventilation slots
3. On / off switch
4. Stand-by mode on / off switch
5. Scale
6. Spindle lock
7. Collet clamp nut
8. Battery*
9. Battery lock*
10. Control button of the state of battery charge*
11. Indicators of the state of battery charge*
12. LED lamp
13. Speed selector thumbwheel
14. Base plate
15. Latch
16. Twist knob
17. Setscrew
18. Parallel guide (assembly)
19. Guide with roller (assembly)
20. Setscrew of dust extractor connecting adaptor
21. Dust extractor connecting adaptor
22. Collet (8 mm)
23. Wrench
24. Charger*
25. Collet (6 mm)
26. Spindle
27. Fixing screw of roller holder
28. Lead screw of roller holder
29. Roller holder
30. Roller
31. Holder of parallel guide
32. Screw of parallel guide
33. Washer of parallel guide
34. Guide
35. Wing nut of parallel guide
36. Indicator (green)*
-1 37. Indicator (red)*
38. Charger label*
Not all of the accessories illustrated or described are
h
and 8 mm
: 3,5 m/s
2
h
2
21