4.
Slip off the belts from the lower belt connector (see: fig. 15b).
5.
Remove the belts from the child safety seat. Close the manual locker.
Assemble the belts in a reversed order.
SEAT LINER
If the child needs more space in the child safety seat, remove the seat liner.
HOW TO ADJUST THE HEADREST AND HEIGHT OF SHOULDER BELTS (fig. 6)
Note! Height of shoulder belts is integrated with the height of headrest.
Group I
To change height of the belts and the headrest: loosen the shoulder belts as much as you can
and then grab the headrest height adjustment lever (O). Choose the desired height and then
release the lever. Try to move the headrest to see if it has been secured properly as desired.
Groups II and III
Slide off the belts from the upper belt connector (Q) located inside the manual locker (R). Pull
out the child safety seat belts in the front and then insert outstanding belt tips in the protective
cushions so that they are not disturbing. Now you can close the locker and lift the headrest.
Hide the belts connector in a safe place for future use.
The height of the headrest must be adjusted so that the shoulder belts are at the child's
arms height. The belts must not be too high (at the ears level or higher), or too low (behind
child's back).
See: fig. 7.
A – too low
HOW TO INCLINE CHILD SAFETY SEAT
It is possible to choose four inclination angles of the child safety seat (fig. 11).
To incline the child safety seat, grab the handle (L) located between the seat and base and
set the desired inclination (fig. 10).
Group I
Positions 1 – 4
B – too high
Groups II, III
Position 1
‑ 11 ‑
C – perfect height of shoulder belts
EN