Final Installation - Vivanco WTL 6 Manual De Instalación

All manuals and user guides at all-guides.com
Do not overtighten the screws and do not let go of the wall bracket before it is correctly installed
on the wall. Also make sure that it is level. Check the tight fit of the bracket by strongly pushing
down the wall bracket arms. The part that is screwed on must not move in the process..
9.3. Installation of the wall bracket arms on the television set
Proceed carefully when installing the television set. Avoid putting the television set down on the side
with the screen, because this can cause the destruction of the screen surface.
This wall bracket is delivered with screws in different lengths and diameter (D/E/F/G/H) in order to
cover the wide variety of different sets of television. You do not require all provided screws, but only
four each. If the correct screw is not provided, please contact the television set manufacturer for
additional information.
a) Determine the correct diameter of the screws by carefully testing each size on the mounting
holes. Do not use force. If you can feel resistance, try a smaller diameter.
b) Determine the correct length of the screws by examining the back of the screen:
- If the back of the screen is flat and the mounting holes are flush with the back, then you require
the shorter screws.
- If the back of the screen is curved, if there is protrusion or if the mounting holes are buried, then
you require the longer screws and possibly the spacers (K) in addition.
The screws should be buried at least 70% in the mounting holes for the screen after installation.
Never install the screen with screws that are too short, because this can cause the television set to
crash. Also make sure that the screws used are not too long, because this could destroy the television
set.
Install the bracket arms on the back of the screen with the screws identified in steps a and b
(D/E/F/G/H) (s. fig. 11).
Use the M6 washers (I) for the M6 screws and the M8 washers (I) for the M8 screws (J).
If you use the longer screws, installation of spacers (K) may be required. You can also use 2 spacers in
series. Use the spacers only if absolutely necessary.

9.4. Final installation

a) Lift the screen carefully into the upper and lower bars of the wall bracket with the assistance of
another person. Do not let go of the screen before it is mounted and locked correctly (fig.12).
b) Close the safety clamps on the lower ends of both arms to prevent unhooking of the screen. The
clamps latch automatically if they are closed completely fig. 13)
The clamps must always be closed to prevent accidental unhooking and crashing of the screen.
c) Carefully re-assemble the plastic covers on the wall bracket.
d) Cables can be lead through cable ducts on the bottom of the wall bracket..
10. Adjusting the wall bracket
a) In order to adjust the inclination angle of the screen, one person holds the screen tight while ano-
ther person loosens the locating screws (fig. 14) with the provided hex driver (L). After loosening,
the screen can be brought into the desired position and the screws can be re-tightened. Do not
let go of the screen before the screws are re-tightened completely. Never remove the locating
screws entirely.
b) For pivoting the television set, hold the screen tight with two hands and move it into the desired
GB
9