Remington HC5950 Manual De Instrucciones página 5

ENGLISH
adjust to the desired cutting length following the steps below.
decreased in 0.5mm increments. Also ensure that the locked button is in the unlocked
position.
the cutting length in 0.5mm increments and setting C will adjust the length in 0.1mm
increments.
Note:
that the comb selection switch is on the wrong setting.
comb will move to reach each setting, the lengths will change as you hold the up/down
arrow, and the setting number will appear on the digital display.
unlocked position. The display will indicate the level.
switch. The display should show a closed lock, and the current length setting and boost
level. Proceed to use the clipper
Note: Adjustments to length and boost can be done anytime the lock switch is set to
unlock. Setting can be done with the main motor of, if the power button is pressed a
second time. To turn the main motor back on the power button needs to be pressed
again.
digital display. This can be used whilst the appliance is locked.
, SWITCHING BETWEEN UNITS OF LENGTH (mm, #)
this time release the power button. The setting has been changed.
Note:
mode
A CAUTION
Once the digital display changes from mm to grade number, release the power button to avoid
an inadvertent restart.
NOTE: The comb must be attached to the appliance in order to use the hair length selector. To
achieve 0.4mm the comb must be removed.
, Touch Lock
into the lock position.
, Before Starting The Cut
5