Headphone Jack - Tokai TB-210 Manual De Instrucciones

5. Turn off your iPod, MP3 player and etc. when finish listening. Turn the unit off and unplug the AUX IN
jack.
Remark: Once the AUX IN jack is plugged, the unit will automatically enter the AUX mode when the
FUNCTION switch is in CD/USB/AUX mode. Remember to disconnect the cable from the unit after
use in order to be able to listen to the unit again.
The LED light shows inside the speaker and around the center display of the unit are created automatically
based on the music source being played at the time.
 To turn on the LED light show, slide LIGHT switch to ON position.
 To turn off the LED light show, slide LIGHT switch to OFF position.
If the brightness is glaring, turn on room lights or turn off LED light show
Note:
Caution: listening at high level for a long period could damage the hearings.
If you don't want to disturb other people during your listening, you can plug a 3.5 mmr
earphones/headphone into the PHONE jack of the back of the unit. The audio from the speakers will be
automatically cut off and you can enjoy your listening from your earphones/headphone.
Establish a safe sound level :
Pay attention! Over time your hearing will adapt to continuous loud sounds and will give the impression that the volume
has in fact been reduced. What seems normal to you may in fact be harmful. To guard against this before your hearing
adapts, set the volume to a low level.
Slowly increase the level until you can hear comfortably and clearly and without distortion. Damage to your hearing is
accumulative and is irreversible. Any ringing or discomfort in the ears indicates that the volume is too loud. Once you
have established a comfortable listening level, do not increase the sound level.
All manuals and user guides at all-guides.com
LED LIGHT SHOWS

HEADPHONE JACK

22