Troubleshooting - Tokai TB-210 Manual De Instrucciones

If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as there is a risk
of electric shock. If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: under no circumstances you should try to repair the set yourself, as this will invalidate the warranty.
PROBLEM
No sound
No power
Display does not
function properly/ NO
reaction to operation of
any of the controls
RADIO
Poor reception
Noise or Sound distorted
AM or FM no sound
CD cannot read
CD skips while playing
Intermittent sound from
CD player
No sound when playing
audio via AUX-IN
Sound appears
distorted at high volume
setting
All manuals and user guides at all-guides.com
TROUBLE SHOOTING
POSSIBLE CAUSE
 Volume not adjusted
 power cord not securely connected
 Electrostatic discharge : under the
influence of electrostatic
phenomenon, the product may
malfunction and require user to
disconnect.
 Station is not tuned properly.
 Unit is not positioned correctly.
 Station is too weak.

Unit not in "AM" or "FM" function
mode.

- Volume set at minimum

Unit not in CD function mode.

AUX IN jack is plugged

CD is not loaded properly.

If the CD is self-compiled, the
media used may not be
compatible with the player.

- Exhausted battery

Disc is dirty or scratched.

Dirty or defective disc

Dirty pick up lens

Player is subject to excessive
shock or vibration
 Audio cable has not been connected
properly.
 Audio cable is damaged.

Volume control is set to maximum.

- Batteries become low
- Adjust the volume knob,
- Connect the AC power cord properly,
- Switch off and unplug the set. Reconnect
after a few seconds
- Adjust tuning control,
- Adjust the unit to the best direction.
- Try other strong stations.
- Slide FUNCTION SWITCH to "AM" or "FM"
position.
- Increase Volume.
- Select CD function mode.
- Unplug cable plugged in AUX IN jack.
- Load CD with label side up.
- Use better quality blank media and retest.
-
- Replace all old batteries.
-
Wipe CD with clean cloth or use another
disc.
- Clean or replace the defective disc.
- Use a CD lens cleaning disc to clean
the lens.
- Relocate the player away from shock or
vibration.
Check the connection of Audio cable
-
between your unit and the external audio
device.
Use another audio cable for connection.
-
- Adjust
comfortable level.
- Replace all the old batteries with new
-
ones.
25
SOLUTION
Volume Control to a lower