Storage; Receiving, Unpacking, First Cleaning - Qualified Operator; Installation And Environmental Conditions - Specialized Technician - Arneg Baden Guía De Instalación Y Manejo

Baden
English
DO NOT use lifting means that have:
with a capacity of less than 1,000 kg
unsuitable characteristics or ones altered by use.
invalid or worn out ropes or wires
DO NOT use transportation procedures other than those indicated

9. Storage

DO NOT store the cabinets in uncovered areas and therefore subjected to
atmospheric agents and to direct sunlight. Exposure to ultraviolet rays causes
permanent deformation of the plastic materials and damages cabinet components.
The cabinets must be stored indoors, with a temperature ranging between-25°C
and +55°C and a humidity between 30% and 90%.
Before storing the cabinets, check that the packing is intact and that it does not
display defect that may compromise preservation of the cabinets.

10.Receiving, unpacking, first cleaning - qualified operator -

Before any unpacking operation, adopt all the precautions possible to avoid injuries to
the operator.
The unit may be provided packaged in one of the following ways:
With frame in wood fixed to the base and nylon casing blocked by straps (standard)
(Rif. 6).
With a cardboard casing (on request) (Rif. 7).
With cage in wood (on request) (Rif. 8).
When receiving the cabinet:
Make sure the packing is intact and that it does not display readily apparent
damages;
Carefully perform the unpacking operation in order not to damage the cabinet;
Check the integrity of the cabinet components;
If any damage is found, immediately contact your supplier;
Slowly remove the protective films without tearing them, to avoid glue residues; the
residues can be removed with appropriate solvents.
Proceed with a first cleaning using neutral products and dry with a soft cloth; do not
use abrasive substances or metallic sponges;
To correctly dispose of the packing, bear in mind that it is made up of: Wood -
Polystyrene - Polythene - PVC - Cardboard.
DO NOT use alcohol to clean the parts in methacrylate (Plexiglas).
During the unpacking operations, do not leave elements of the packing
unattended such as nails, wood, gripper rods, nylon, etc. and tools used for
the operation such as pliers, scissors, pincers, in the work area, which could
cause wounds and injuries.
These objects must be removed with appropriate means and brought to their
respective collection places.

11.Installation and environmental conditions - specialized technician -

Any modification to the installation described herein must be authorized by
ARNEG Spa
To ensure that the technicians appointed to installation may operate safely, we
recommend to use the instruments and protection clothing required by the safety
norms or by the laws in force in the country of installation. At any rate, always use
adequate equipment and clothing, such as: anti-injury boots, protection gloves,
spirit level.
For the installation, adhere to the following:
carefully examine the installation area, eliminating any danger to the operator;
Do not position the cabinet:
28 05060141 01 05-2022