Kenwood LZ-601 Manual De Instrucciones página 5

Installation for Monitor Unit
Installation location and cleaning
Select for installation a location where the stand can be placed completely horizontal or
where the front edge of the support (petal-shaped part) can be attached horizontally as
shown in Figure A.
Do not install in locations where the entire support is at a diagonal such as in Figure B or
where the monitor unit is facing down such as in Figure C.
2CAUTION
Thoroughly wipe away and dust or grease from the installation location using a cloth which
has been soaked in a neutral cleaning agent and wrung out. Attach the stand after allowing
the installation location to dry.
1
Bend the stand support to conform to the shape of the installation location.
2
Adjust the shape of the support so that there is no rattling or gap when the stand is
placed on the support.
3
Peel off the protective strip from the double-sided tape on the bottom of the stand and
securely attach the stand.
2CAUTION
• Do not attach the double-sided tape more than once or touch the adhesive with your
fingers as this will weaken its adhesive strength.
• If the temperature of the surface of the installation location is low, warm it up using a
heater or other means before attaching the stand. Low temperature may weaken the
adhesive strength of the tape.
• The supplied stand is specially intended for this product. Do not use it with another
monitor.
4
Secure the stand using the supplied tapping screw (Accessory 3).
5
After attaching the stand, allow it to sit undisturbed for 24 hours.
6
Take care not to apply any force to the stand during this time.
7
Fully loosen the installation screws, align the slit on the rear of the unit with the
installation shoe and slide the monitor unit onto the stand.
8
Adjust the height, horizontal angle and vertical angle of the monitor and securely tighten
the installation screws.
You can also adjust the monitor unit's forward position by loosening the angle
adjustment knobs and adjusting the angle of the monitor unit's installation stand.
All manuals and user guides at all-guides.com
A
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
C
B
;;;;;;;;;
;;;;;;;;;
;;;;;;;;; ;;;;;;;;
;;;;;;;;; ;;;;;;;;
;;;;;;;;; ;;;;;;;;
;;;;;;;;; ;;;;;;;;
;;;;;;;;; ;;;;;;;;
;;;;;;;;; ;;;;;;;;
;;;;;;;;; ;;;;;;;;
;;;;;;;;; ;;;;;;;;
;;;;;;;;; ;;;;;;;;
English - 5