Fall Arrest - Hilti NCR 120 PC-A22 Manual De Instrucciones Original

5.5 Fitting the crimping / pressing die
WARNING
Risk of injury! Unintentional starting.
▶ Remove the battery before inserting, changing or removing the crimping die.
Never operate the crimping / pressing tool without a crimping / pressing die in place!
1. Remove the battery and select the most suitable crimping / pressing die.
2. Push the crimping / pressing dies in until they engage.
3. Rotate the crimping / pressing head to the desired working position.
The crimping / pressing head can be rotated much more easily when not under pressure.
5.6 Removing the crimping die
WARNING
Risk of injury! Unintentional starting.
▶ Remove the battery before inserting, changing or removing the crimping die.
1. Remove the battery and rotate the crimping / pressing head into the outset position.
2. Press the lockbuttons and remove the crimping / pressing dies.
5.7

Fall arrest

WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only the Hilti tool tether #2261971.
▶ Use the loop to secure the tool tether to the product
as shown in the illustration. Check that it holds
securely.
▶ Secure the carabiner to a load-bearing structure.
Check that the carabiner holds securely.
Comply with the operating instructions of the
Hilti tool tether.
*2215654*
2
3
2215654 English 21