Zanussi ZWH6100 P Manual De Instrucciones página 10

Follow the product manufacturer's
recommendations on quantities to use and do
not exceed the MAX mark in the detergent
dispenser drawer.
Do not spray stain pre-treatment products
(e.g. Vanish) on or near the machine, as it
can attack plastic materials reducing its life.
Quantity of detergent to be used
The type and quantity of detergent will depend
on the type of fabric, load size, degree of soiling
and hardness of the water used.
Water hardness is classified in so-called
"degrees" of hardness.
Information on hardness of the water in your
area can be obtained from the relevant water
supply company, or from your local authority.
Follow the product manufacturers' instructions
on quantities to use.
Not enough washing powder causes:
the washload to turn grey,
greasy clothes.
Too much washing powder causes:
sudsing,
reduced agitation and washing effect,
inadequate rinsing.
Use less detergent if:
you are washing a small load,
the laundry is lightly soiled,
large amounts of foam form during washing.
Open the detergent dispenser drawer
The detergent
dispenser is
divided into three
compartments.
10
Compartment : this compartment is
only used for washing powder when a
program has Prewash or Stain.
Compartment : this compartment is
used for washing powder or liquid.
Compartment : this compartment is used
for fabric conditioner and starching agent.
Aways add laundry detergents before switching
the machine on and keep the dispenser clean
and dry, so that the detergent can be efficiently
dispensed from the unit.
Add the detergent
When using the washing machine for the first
time, check that the dispenser is set for the
type of detergent you will use.
To do this, proceed as follows:
Pull the dispenser drawer forward until it
stops.
Remove the drawer. Push the drawer edge
outwards where indicated by the arrow
(PUSH) to facilitate drawer removal.
pressing the catch
downwards and by
pulling it out.
Check the position of the flap at the "
detergent compartment in the dispenser
drawer. (Factory setting is flap up for
powder.)
UP- Flap position if DOWN - Flap position
using POWDER if using LIQUID
detergent. detergent.
"