Agio 2127022 Manual Del Usuario página 7

4. Pour ALL of the provided media (fire ice) into the burner pan. The burner MUST be
completely covered to ensure the appliance functions properly and safely. Remove any fire
ice on top of the ignition well. See figure 5.
Figure 5
5. Slide the tank drawer out and place the LP tank in the drawer. Connect the regulator as
shown in Figure 6. Turn the black handle clockwise to tighten. Turn the handle
counterclockwise to remove. The hose must point down. Check that the valve is turned all
the way clockwise to the "OFF" position. Open the tank valve. Apply a solution of soapy
water to the tank-regulator connection and to the valve-hose connection to check for leaks.
If soap bubbles continue to form, the connection has a leak. If a leak is found, close the tank
valve and tighten all connections.
NEVER USE A FLAME TO CHECK FOR LEAKS.
Figure 6
6. Tighten the threaded knobs (G) found on the tank tray so that the LP tank cannot move
from side to side. Do not remove the plastic cap from the end of the threaded section. See
figure 7.
Figure 7
7