Maintenance; Lighting Instructions; Burner Cover Assembly; Control Knob - Agio 2127022 Manual Del Usuario

The flames should look like those in Figure 10. To clean the
burner, use a soft brush after the burner has cooled
completely. Never use a vacuum cleaner on the burner. It is
recommended to store the fire pit indoors during winter if it
will be subjected to freezing temperatures. The LP cylinder
must be disconnected and removed from the appliance
before the appliance can be stored indoors.
Warning: If these instructions are not followed exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.
IGNITER BUTTON
1. Read instructions before lighting.
2. Push and turn the knob to ON.
3. Hold ignitor to light the burner, release control knob after 15 seconds; if burner does not
light , wait 5 minutes ,repeat.
4. Adjust flame to desired flame with the control knob. See Figure 11.
Place the burner cover on the table top as shown in Figure12.
WARNING: BEFORE PLACING THE BURNER COVER ON, MAKE
SURE THE FIREPIT HAS BEEN SHUT OFF AND THE BURNER
HAS COMPLETELY COOLED DOWN.

MAINTENANCE

LIGHTING INSTRUCTIONS

BURNER COVER ASSEMBLY

Figure 12
Figure 11
10
Figure 10

CONTROL KNOB