brennenstuhl Primera-Tec Comfort Switch Plus 19.500A Instrucciones De Uso página 14

041610 Primera-Tec_041610 Primera-Tec Comfort Switch 1 04879
Operating Instructions Primera-Tec
control light "Protection on" will light up, indica-
ting that surge voltage protection is effective. If
the control light does not light up any more, the
protection is no longer effective and the sockets
get disconnected. In this case the device must be
changed, since the protective components have
been destroyed by a very high voltage surge.
Permanent sockets
The permanent sockets are surge protected and,
independent from the status of the external
hand/foot switch, always on.
External hand/foot switch
The switchable sockets "ON/OFF" can be two-pole
switched on and off by the external hand/foot
switch. The switching status is shown by the
control light at the hand/foot switch. In this way
the connected devices can be switched comforta-
ble, while the extension socket can be in a hidden
position.
To get a simple installation, the external hand/foot
switch is supplied with a connector. With a push on
the clip of the RJ-11 plug it can be released from
the extension socket, positioned comfortable, if
necessary put through a small hole and start
operating with just plug in again. If the 1.5m
control line on the external switch is too short for
your application, you can extend it by using a RJ-11
extension line (6p4c with 1:1 pinning) out of the
14