Technical Features; Preset And User Modes; Power Saving Function; Troubleshooting - Sony GDM-F400T9 Manual De Instrucciones

Technical Features

Preset and user modes

When the monitor receives an input signal, it automatically
matches the signal to one of the factory preset modes stored in the
monitor's memory to provide a high quality picture at the center of
the screen. (See page i for a list of the factory preset modes.) For
input signals that do not match one of the factory preset modes, the
digital Multiscan technology of this monitor ensures that a clear
picture appears on the screen for any timing in the monitor's
frequency range (horizontal: 30 – 107 kHz (GDM-F400T9) or 30
– 121 kHz (GDM-F500T9), vertical: 48 – 160 Hz) . If the picture
is adjusted, the adjustment data is stored as a user mode and
automatically recalled whenever the same input signal is received.
Note for Windows users
For Windows users, check your video board manual or the utility
program which comes with your graphic board and select the
highest available refresh rate to maximize monitor performance.

Power saving function

This monitor meets the power-saving guidelines set by VESA,
E S
NERGY TAR, and NUTEK. If the monitor is connected to a
computer or video graphics board that is DPMS (Display Power
Management Signaling) compliant, the monitor will automatically
reduce power consumption in three stages as shown below.
Power mode Power
consumption*
≤ 160 W (GDM-F500T9)
normal
≤ 140 W (GDM-F400T9)
operation
≤ 100 W (GDM-F500T9)
1 standby
≤ 80 W (GDM-F400T9)
≤ 15 W (GDM-F500T9)
2 suspend
≤ 10 W (GDM-F400T9)
≤ 1 W (GDM-F500T9)
3 active off**
≤ 3 W (GDM-F400T9)
power off 0 W
* Figures reflect power consumption when no USB compatible
peripherals are connected to the monitor.
**When your computer enters the "active off" mode, the input signal is
cut and NO INPUT SIGNAL appears on the screen. After the time set
in "Changing the power saving delay time." (page 14) has elapsed, the
monitor enters the power saving mode.
To change the power saving delay time
See page 14.

Troubleshooting

Before contacting technical support, refer to this section.
If thin lines appear on your screen
(damper wires)
The lines you are experiencing on your screen are normal for the
Trinitron monitor and are not a malfunction. These are shadows
from the damper wires used to stabilize the aperture grille and are
most noticeable when the screen's background is light (usually
white). The aperture grille is the essential element that makes a
Trinitron picture tube unique by allowing more light to reach the
screen, resulting in a brighter, more detailed picture.

On-screen messages

If there is something wrong with the input signal, one of the
following messages appears on the screen. To solve the problem,
see "Trouble symptoms and remedies" on page 16.
1 (power)
indicator
green
green and orange
1 The input signal condition
alternate
green and orange
alternate
orange
off
2 The connector indicator 2 2 2
Damper wires
INFORMATION
OUT OF SCAN RANGE
INPUT : HD15
OUT OF SCAN RANGE
indicates that the input signal is not supported by the
monitor's specifications.
NO INPUT SIGNAL
indicates that no signal is input, or that no signal is input from
the selected connector (HD15 or BNC).
This message indicates which connector is receiving the
wrong signal. If there is something wrong with the signal
from both connectors, HD15 and BNC are displayed
alternately.
GB
15