Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRICAL REQUIREMENTS AND SAFETY
Be sure your extension cord is properly wired and in good
condition. Always replace a damaged extension cord or
have it repaired by a qualified person before using it. Pro-
tect your extension cords from sharp objects, excessive
heat and damp or wet areas.
Use a separate electrical circuit for your tools. This circuit
must not be less than a #12 wire with a 20 A time lag fuse
or a #14 wire with a 15 A time lag fuse.
NOTE: When using an extension cord on a circuit with a
#14 wire, the extension cord must not exceed 25 feet in
length. Before connecting the tool to the power line, make
sure the switch is in the OFF position and the electric cur-
rent is rated the same as the current stamped on the mo-
tor nameplate, running at a lower voltage will damage the
motor.
ACCESSORIES AND ATTACHMENTS
RECOMMENDED ACCESSORIES
WARNING
• Use only accessories recommended for this miter saw.
Follow instructions that accompany accessories. Use of
improper accessories may cause hazards.
• The use of any cutting tool except 10 in. saw blades which
meet the requirements under recommended accessories is
prohibited. Do not use accessories such as shaper cutters
or dado sets. Ferrous metal cutting and the use of abrasive
wheels is prohibited.
• Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration or
modification is misuse and could result in a hazardous
condition leading to possible serious injury.
TOOLS NEEDED FOR ASSEMBLY
Supplied
Blade wrench
(supplied)
Screwdriver Phillips
Not supplied
Adjustable wrench
Hex Key 2.5mm
Combination square
MINIMUM GAUGE FOR EXTENSION CORDS (AWG)
(When using 120 volts only)
Ampere Rating
More Than Not More Than
0
6
6
10
10
12
12
16
CAUTION In all cases, make certain the receptacle
is properly grounded. If you are not sure, have a
qualified electrician check the receptacle.
ACCESSORIES
Visit your Knova Hardware Department or see the Knova Power
and Hand Tool Catalog to purchase recommended accessories
for this power tool.
WARNING
To avoid the risk of personal injury, do not modify this power
tool or use accessories not recommended by Knova.
WARNING
Read warnings and conditions on your CARBIDE TIPPED SAW
BLADE. Do not operate the saw without the proper saw blade
guard in place. Carbide is a very hard but brittle material. Care
should be taken while mounting, using, and storing carbide
tipped blades to prevent accidental damage. Slight shocks,
such as striking the tip while handling, can seriously damage
the blade. Foreign objects in the workpiece, such as wire or
nails, can also cause tips to crack or break off. Before using,
COMBINATION SQUARE MUST BE TRUE
Should not gap or overlap when square is flipped over (see
dotted figure).
Draw light line on
board along this edge.
4
Total length of Cord
25ft. 50ft.
100ft.
18
16
16
18
16
14
16
16
14
14
12
Not Recommended
Straight edge or a 3/4 in. board, this
edge must be perfectly straight.
Gap from untrue square
when flipped over.
150ft.
14
12
12
Publicidad
Tabla de contenido
