Glossary Of Terms For Woodworking; Motor Specifications And Electrical Requirements - KNOVA KN SS-162 Manual Del Usuario

GLOSSARY OF TERMS FOR WOODWORKING

1. Kerf the slot cut by the blade.
2. leading edge the edge of the workpiece, which pushed
into the blade first
3. Saw blade Path the area of the workpiece directly in line
with and moving toward the saw blade edge.
Workpiece

MOTOR SPECIFICATIONS AND ELECTRICAL REQUIREMENTS

WARNING:
Rating, power supply cord with plug and grounded outlet indi-
cated hereby are according to electrical regulations of United
States and Canada. For other countries, they may be different.
therefore, for the actual electrical rating please see marking
on this machine, however for any details of the information on
power supply cord with plug and the grounded outlet, please
consult a qualified electrical technician.
this machine is equipped with a one-speed switch for greater
versatility. It is wired for operation on 110 120 volts, 60 Hz,
alternating current.
COnneCtInG tO POWeR SUPPly OUtlet
If power cord is worn or cut, or damaged in any way, have it
replaced immediately.
WARnInG Improper grounding can shock, burn or electro-
cute.
Grounding of this tool is necessary while in use to protect you
from electric shock or electrocution. this tool is equipped with
an approved three-conductor cord and three prong ground-
ing type plug to fit the proper grounding type receptacle. do
not remove grounding prong from the three-prong grounding
type plug. the green (or green and yellow) conductor in the
cord is the grounding wire. never connect the green (or green
and yellow) wire to a live terminal.
4. blade tooth Set the distance that the edge of the saw blade
tooths is bent (on set) outward from the side of the blade.
5. trailing edge the work piece edge last cut by the saw
blade.
6. Work Piece the Item on which the cutting operations is
being performed.
Kerf leading edge
Saw blade Path
trailing edge
this plug requires a mating 3 conductor grounded type outlet
as shown.
WARnInG: dO nOt PeRMIt FInGeIRS tO tOUCH tHe
teRMInAlS OF PlUGS WHen InStAllInG OR ReMOVInG
tHe PlUG tO OR FROM tHe OUtlet.
4
blade toofth Set
3 PROnG PlUG
GROUndInG PROnG
AlWAyS USe A
GROUnded OUtlet