Operation - Waldbeck Azteca Manual De Instrucciones

EN
28

OPERATION

LCD
• Mode Cursor: indicate the operation mode, altogether divided into four
kinds.
• Target ID Cursor: divided into 6 categories. It is used to indicate the
target metals.
• Digital ID Cursor/Pinpoint Cursor: two digits of 01 to 99 finely indicate
the material of metal. It also acts as a P-P cursor, when displaying P-P
characters, it enters the Pinpoint state.
• Coin Depth Cursor: divided into five files. Indicates the approximate
depth of 25 silver coins in neutral soil.
• Signal strength cursor: indicates the signal strength when in the Pinpoint
state.
• Volume cursor: indicates the volume.
• Sensitivity indicator cursor: divided into five files, all lights are the
highest.
• Battery power cursor: divided into four files, indicating battery power.
When the battery pattern flashing, which means the battery should be
replaced.
MODE SENS
1. Press the MODE button, cycle selection in four ways.
a. A-M – all metal state. To all the detected metals, the detector will
respond.
b. DISC – discriminate state. The discrimination quantity can be
adjusted, and reject the metals that don't need to be detected.
c. MEMORY – remember some kind of metals you choose, and will only
respond to this metal.
d. JEWELRY – reject iron, that is, it won't respond to iron, but it will
respond to other metals.
2. Press the SENS button, (- +) buttons to adjust the sensitivity.
+/– button
There are two functions
1. Press SENS button, the sensitivity cursor will flash, and the (-/+) button is
used to adjust sensitivity.
2. In DISC mode, the (-/+) button is used to adjust the discrimination
quantity.