Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GATE MODE
OK ALL SIGNAL
STORE JOB
BARCODE
BARCODE SETTING
How to select/switch
Job by barcode
scanning
BATCH MODE
TIME SETTING
46
None/Once/Twice
Once/Each
1~50
Define a valid barcode
range
From: 01~54
Bits: 01~54
To Binding JOB
(01~50)
INC/DEC
YYYY/MM/DD
HH: MM: SS
None: Function off.
Once: Workpiece in
position (Short signal.)
Twice: Workpiece in/
out position (Open
signal).
OK ALL signal output
method
Once: Output OK
ALL signal after all
sequences completed.
OK ALL signal output
time depends on At
setting.
Each: Output OK
ALL signal after each
sequence completed.
OK ALL signal output
time depends on At
setting.
"Scan job barcode
"will show after
pressing. After using
scanner to scan
barcode, it will save
barcode into controller
automatically.
Setup sequence 1
to 50, it will switch to
barcode sequence.
Barcode length should
not exceed 54 bits.
Below steps will
show you how to use
certain section of a
barcode to select/
switch Job.
Step 1. Determine
the initial point of the
section (01-20)
Step 2. Determine
section size (01-20)
Step 3. Assign
selected section to
Job (01-50)
Select count up or
count down
Set up controller time
Year/Month/Day/Hour/
Minute/Second.
OFF
Once
01
Job: 01
From: 01
Bits: 01
DEC
2018/01/01
01:01:01
Publicidad
Tabla de contenido
