EGAmaster 66549 Manual De Instrucciones página 78

STEP 4
After setting parameters to Program 2 in Tightening Program (TP), then click button to save
the data to the controller.
NOTE: Input "0" to the steps which are not activated.
NOTE: The digit "2" in the "The First Step" is a new setting, the detail setting condition of
Step 2.
STEP 5
After setting parameters to Step 2 in Tightening Step (TS), then click
the data to the controller.
NOTE: Step 2 was already assigned to "The First Step" of Program Nº.2 previously.
78
button to save