Replacing The Remote Control Batteries; Setting The Time - Dometic FJ1700 Instrucciones De Uso

Ocultar thumbs Ver también para FJ1700:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 73
Operating the roof air conditioner
I
NOTE
The
button on the remote control is activate even if the remote control is turned off.
Switching the light on/off with the control panel
➤ Briefly press the
Dimming the light with the control panel
➤ Press and hold the
Switching the light on/off with the remote control
➤ Press the
button to switch the lamps on or off.
✔ The
symbol appears in the display when the lights are turned on.
Dimming the light with the remote control
➤ Press the
button for 2 s.
✔ The
symbol flashes in the display.
➤ Press and hold the – button or the + button until the lights have been dimmed to the required brightness.
You can dim the lights to 20 %, 40 %, 60 %, 80 % and 100 %.
➤ Press the
button again to disable the dimming function.
✔ The
symbol is lit constantly.
9.13

Replacing the remote control batteries

Replace the batteries if you see the
The battery compartment is on the back of the remote control.
➤ Gently push down the lid of the battery compartment and slide it open in the direction of the arrow.
➤ Insert the new batteries (2x type AAA) in the remote control as indicated in the battery compartment.
➤ Close the cover of the battery compartment.
B
Protect the environment!
Do not dispose of batteries with general household waste.
Return any used batteries to your retailer or take them to a collection point.
9.14

Setting the time

The remote control needs the current time in order to program the timer. The time is indicated on the display of the
remote control.
Perform the following steps to set the time:
I
NOTE
The remote control returns to its initial mode and saves the current setting, if no key is
pressed on the remote control for 15 seconds while setting the time.
➤ Press and hold the
✔ The time flashes on the display of the remote control.
➤ Use the + or – button to set the current time.
Press the + or – button longer than 2 s to increase or decrease the time quicker
➤ Press the SET button to confirm the time.
28
button to switch the lamps on or off.
button until the lights have been dimmed to the required brightness.
symbol on the display.
button for 2 s.
FJ 1700, FJ 2000, FJ 2200, FJ 3200
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Fj2000Fj2200Fj3200

Tabla de contenido