Horizontal Cut (With Straight Cutter Bar); Mounting The Drive Tube - Stihl HLE 71 Manual De Instrucciones

Ocultar thumbs Ver también para HLE 71:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
English
3.5.4
Top trimming (with angled cutting bar)
Hold and swing the hedge trimmer vertically, this
results in a larger range.
WARNING
Overhead working positions are tiring and should
be used only for short periods for reasons of
work safety. Set the adjustable cutter bar to the
most suitable angle so that the trimmer can be
held in a lower, less tiring position while still pro‐
viding adequate reach.
3.5.5

Horizontal cut (with straight cutter bar)

Cutting without standing directly next to the
hedge, e.g. flowerbed between operator and
hedge.
Hold the cutter bar at an angle of 0° to 10° as
you swing the hedge trimmer horizontally.
Swing the blade in an arc towards the outside of
the hedge so that the cuttings fall to the ground.
26
4

Mounting the Drive Tube

2
3
A
► Pull the protective cap off the drive tube.
► Push the drive tube (1) into the motor hous‐
ing (2) as far as the mark (A), turning the drive
tube back and forth at the same time.
► Tighten down the screw (3) in the housing
firmly.
4 Mounting the Drive Tube
1
A
0458-277-9821-B

Publicidad

Tabla de contenido
loading

Tabla de contenido