Installation - Mounting Bracket And Track - Permobil Compass Power Mount Hardware Operación Manual

Installation - Mounting Bracket and Track Alignment
Verify and/or switch the mounting bracket orientation; or replace the mounting bracket and male track parts.
If the mounting bracket is already set up for the
wheelchair, see the Installation instructions on the
next two pages.
If the mounting bracket orientation needs to be
switched, follow steps 3a - 8a on this page.
The mounting bracket should be set up for the
power wheelchair that was selected when the
product was ordered.
To determine whether to use SIDE A or SIDE B of the
mounting bracket, look for the location of the male
track pieces that have notches, as shown here.
To adjust the mounting bracket:
3a From the back side of the mounting bracket (B),
unscrew the four flat head screws (E) with the
hex key.
4a Move the male tracks (D) to the opposite sides of
the mounting bracket.
Note: The notches on the male tracks must be visible
and run along the outer edge of the mounting
bracket.
5a Reassemble the mounting bracket (B) and the
male tracks (D) using the screws (E).
IMPORTANT! The screws should be evenly
tightened for the best alignment.
To check track alignment:
6a With both release levers (A) in the open position,
slide the male tracks into the female tracks of the
hardware assembly. It should slide up and down
easily.
7a If the hardware assembly does not slide easily,
locate the eight screws on the rear face of the
track assembly. Gently loosen all eight screws.
8a Tighten screws 1 through 8 in the order shown.
Repeat steps until the assembly slides easily, and
then continue with the installation instructions on
the next two pages.
If needed, see the instructions on cleaning and
lubricating track pieces, see "Cleaning and Alignment -
Tracks" in this manual.
Compass Power Mount Hardware Operation Manual
SIDE A
QUANTUM, QUICKIE or ROVI
Countersunk holes (x4)
Large
cut-out
B
5a
A
1
5
8
4
7
Male tracks with notches
3a
Note: Notches on the male track should
4a
point outward and away from each other.
6a
SIDE B
PERMOBIL only
Peg hole cut-outs (x2)
Peg hole cut-
outs (x2)
Cut-outs (x2)
D
4a
3
7
6
2