VONROC WL502DC Traducción Del Manual Original página 4

EN
3. OPERATION
The rechargeable work light must be
charged before fi rst use.
Charging
Use the supplied USB cable (8) to charge the re-
chargeable work light.
• Insert the USB Micro-B connector (9) into the
USB input (4)
• Insert the USB A connector (10) into a suitable
USB power outlet, such as a USB wall adapter,
or a computer USB port.
• Observe the charge level indicator (5) to moni-
tor the charging process. The charge indicator
will blink to indicate charging is in progress.
Power button
When the light is on, press the power button (2)
to cycle between the following available operating
modes.
• Full brightness
• 50% brightness
• SOS fl ashing pattern
• Strobe fl ashing pattern
• Light off
When the light is off, press the power button (2)
once to activate the charge level indicator (5).
The charge level indicator will display the current
state of the battery for a few seconds. Press the
power button again to activate the light and cycle
between the operating modes as mentioned above.
USB power bank function
The rechargeable work light may be used a power
bank to power or charge other USB compatible de-
vices from the USB output (3). The power button (2)
and the chosen operating mode of the work light
have no effect on the USB output. The USB output
is always active, provided the internal battery of the
work light has suffi cient charge.
To use the power output, fi nd a suitable USB cable
and plug the USB A connector into the USB output
(3) of the rechargeable work light. Plug the other
end of the USB cable into the target device. The
charge level indicator (5) will automatically light up
to signal that the power output has been activated.
4
4. MAINTENANCE
Always switch off the work light before
cleaning and maintenance.
Clean the rechargeable work light regularly with
a soft cloth. Remove persistent dirt using a moist
cloth with a mild detergent. Never use any solvents
or aggressive cleaning products such as gasoline,
alcohol, ammonia, etc. Such chemicals will cause
irreparable damage to the synthetic components of
the work light.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the im-
WWW.VONROC.COM