Lionelo Henny Manual De Usuario página 6

• Do not use the product if any components are broken or missing.
• Do not use accessories or replacement parts other than those approved by
the manufacturer.
Folding
No.
1
2
3
1.
Combine the seat tubes. Slide the tubes into the guides unti l they lock in
place. The "click" sound indicates proper connecti on. Repeat the procedure
with the other side (fi g. 1).
2.
Then, install the tube that supports the seat (see the below picture). Insert
the steel part of the tube (with the plate) into the bott om of the seat base
and ti ghten it with screws. Use the screws with the following number: 2 -
for outer holes; 1 - for inner holes (fi g. 2).
3.
Installing the caps: Insert the left and right cap into the base tube, as shown
in the picture below. The cap holes must overlap with the holes in the tubes
(fi g. 3). Use screws number 3 to att ach the feet.
4.
Att ach the bases of the swing chair with the connecti ng tubes. Slide the
tubes into the guides unti l they lock in place. The "click" sound indicates
proper connecti on (fi g. 4).
5.
Combine the connecti ng tubes with the swinging mechanism (paying
att enti on to the marks on the tubes). Slide the tubes into the guides unti l
they lock in place. The "click" sound indicates proper connecti on (fi g. 5).
6.
Combine the seat supporti ng tube with the swinging mechanism. Slide the
tubes into the guides unti l they lock in place. The "click" sound indicates
proper connecti on (fi g. 6). Use screw number 3 to additi onally secure the
connecti on.
EN
Snapshot
‑ 6 ‑
Quanti ty
2
4
2
1