7.
Put the canopy on the seat frame so that the holes in the canopy handle
match the seat frame pin (fig. 7).
8.
A child sitting in a seat must be secured with the safety harness (fig. 8). The
length of the belts can be adjusted with the clasps (fig. 9).
9.
The swing chair's seat angle can be adjusted to three different positions. Press the
adjustment button (behind the seat) and choose a desirable position (fig. 10, 11).
The seat can also be flipped (fig. 12).
10. It is possible to fold the bases for storage purposes. Press the buttons at
the bottom of the swinging mechanism and fold the bases (fig. 13).
11. There are two methods of powering the LO-Henny swing chair:
a.
with an included power supply (fig. 14);
b.
with 4 D+ R20 1.5V batteries.
WARNING
• Do not charge non-rechargeable batteries.
• Rechargeable batteries can only be charged by adults.
• Rechargeable batteries should be taken out of the device's battery
compartment before charging.
• Do not plug in the power supply if the batteries are installed in the unit.
• Do not mix used batteries with the new ones.
• Do not mix different kinds of batteries.
• Do not mix rechargeable and non-rechargeable batteries.
• Make sure the batteries are properly installed according to correct polarity (+ -).
• Remove exhausted batteries from the device.
• Use the original power supply (included with the product) only.
• Keep batteries and the power supply away from children.
• If you plan not to use the device for extended period of time, please remove
the batteries and disconnect it from the power supply.
• To replace the batteries in the product, remove the battery compartment
cover and replace the batteries. Replace the cover.
• Transformers used with the infant swing are to be regularly examined for
damage to cord, plug, enclosure and other parts, and in the event or such
damage, they shall not be used.
‑ 7 ‑
EN