Cleaning The Filter Cartridge - Kemper Dusty Evo Instrucciones De Servicio

7. The product is assembled in reverse order. To do this, place the filter unit
+ fan unit (Pos. 1+2) on the lower part (Pos. 3) and close the two clamp
fasteners (Pos. 4), making sure that the seal is correctly seated.
8. Connect the product to the power supply and put it back into operation.
(see also "Commissioning" chapter)

7.2.2 Cleaning the filter cartridge

If the signal lamp for filter saturation lights up, the filter cartridge needs to
be cleaned.
Pos. Description
1 Fan unit
2 Filter unit
Clean the filter cartridge as follows:
1. Switch off the product and disconnect it from the power supply by
unplugging.
2. Release the fan unit (Pos. 1) from the filter unit (Pos. 2) by opening the
two clamp fasteners (Pos. 4).
1502937-00
Fig. 23: Cleaning the filter cartridge
Pos.
3
4
6
Tab. 19: Cleaning the filter cartridge
- 69 -
Description
Lower part
Clamp fasteners
Filter cartridge
EN