Getting Started; Switching On; Playing Discs; Basic Playback Controls - Pioneer PD-D6-J Manual De Instrucciones

04

Getting started

Chapter 4
Getting started

Switching on

After making sure that everything is connected
properly and that the player is plugged in, push
the POWER button into the ON position to
switch the player on.
• Press  on the remote to switch the unit
into standby.
POWER
POWER
STANDBY
OFF ON PURE AUDIO

Playing discs

The basic playback controls for playing CDs,
SACDs, and MP3/WMA discs are covered
here. Further functions are detailed in Other
playback features on page 13.
PROGRAM REPEAT
1 If the player isn't already on, press
POWER to switch it on.
Press  (OPEN/CLOSE) to open the disc
2
tray.
12
En
OFF ON
DIMMER OPEN/CLOSE
PURE AUDIO
1 2 3
CLEAR
4 5 6
ENTER
7 8 9 0
RANDOM TIME
3 Load a disc.
Load a disc with the label side facing up, using
the disc tray guide to align the disc. Once
properly seated, press  to close the disc tray.
Press  (play) to start playback.
4

Basic playback controls

The table below shows the basic controls for
playing discs.
Button What it does

Starts playback.

Pauses a disc that's playing, or
restarts a paused disc.
/
Starts playback/stops a disc that's
(front
playing.
panel only)
• While depressing /, press 
(front panel only). Counting from the
first track on the disc, playback will
begin from the track number
corresponding to the number of
times  is pressed.

Stops playback.

Press to start fast reverse scanning.

Press (play) to resume normal
playback.

Press to start fast forward scanning.

Press (play) to resume normal
playback.

Skips to the start of the current
track, then to previous tracks.