04
Getting started
Chapter 4:
Getting started
To turn the power on
Press the
STANDBY/ON to turn the power on.
After use:
Press the
STANDBY/ON to enter the power stand-by mode.
Note
• In standby mode, if iPod/iPhone/iPad is connected, the
unit turns charge mode.
Setting the clock
STANDBY/ON
OPEN/CLOSE
DVD/CD
USB
TUNER
BT AUDIO
CLOCK/TIMER
AUDIO
SUBTITLE
ANGLE
1
2
3
1
Press
STANDBY/ON to turn the power on.
2
Press CLOCK/TIMER on the remote control.
"CLOCK" is shown on the main display.
3
Press ENTER.
4
Press
to set the day, then press
ENTER.
5
Press
to set the hour, then press
ENTER.
6
Press
to set the minute, then press
ENTER to confirm.
7
Press ENTER
To confirm the time display:
Press the CLOCK/TIMER. The time display will appear for
about 10 seconds.
To readjust the clock:
Perform "Setting the clock" from step 1.
Note
• When power supply is restored after unit is plugged in
again or after a power failure, reset the clock.
16
En
TOP MENU
TUNE+
AUDIO IN/LINE
ENTER
SLEEP
HOME MENU
EQUALIZER
PRESET
TUNE–
General control
Input function
When the INPUT on main unit is pressed, the current function
will change to different mode. Press the INPUT repeatedly to
select desired function.
DVD/CD
LINE
Display brightness control
MENU/PBC
Press DIMMER to dims the display brightness. The
brightness can be controlled in four steps.
Volume auto set-in
RETURN
If you turn off and on the main unit with the volume set to 31
or higher, the volume starts at 30.
VOLUME
Volume control
Turn the volume knob towards VOLUME (on main unit) or
press VOLUME +/– (on remote control) to increase or
decrease the volume.
CAUTION
• The sound level at a given volume setting depends on
speaker efficiency, location, and various other factors. It
is advisable to avoid exposure to high volume levels. Do
not turn the volume on to full at switch on. Listen to
music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
Muting
The volume is muted temporarily when pressing the MUTE on
the remote control. Press again to restore the volume.
FM
USB/iPod
AUDIO IN
BT AUDIO