probst QJ-600-E Instrucciones De Uso página 46

General
•
The load (stone slabs) which is to be sucked and
transported, must have sufficient inherent stability,
otherwise there is risk of breakage when lifting!
•
Stone slabs must not be bend when lifting - especially
take care with thin and large-sized stone slabs!
•
Generally, the load (stones slab) is only to be sucked in
the middle, otherwise the load hangs diagonally under
the device which may cause a breaking of the load -
especially when lifting large stone slabs with a small
suction plate.
•
Standard suction plates are not suitable for the
transport of glass plates!
Only suction plates of the manufacturer PROBST shall be used!!!
•
Some suction plates which can be mounted to the device will reduce its carrying capacity.
The maximum load is indicated on each suction plate.
•
Use only suction plates which are approved for this device!
Do not exceed the maximum carrying capacity of the suction plates!
Danger: Load (stone slabs) will fall down!
52400045 / 52400049 14 / 29 GB