Installation Honda Generator Eu 22I - probst QJ-600-E Instrucciones De Uso

Installation
4.2

Installation HONDA generator EU 22i

When installing the Honda generator to the designated place on the device "QJ-600-E", the vacuum blower
must be switched off. The device must be stand completely on the floor (on even ground).
1. Remove the power cable from power cable
holder (1) and pull off the cable socket (2)
from the cable plug (3).
2. Then attached the electric socket at the
terminal clamp () (in front of the blower
unit).
3. Pull both spring bolts a little out (right and
left of the device) then turn and release it.
52400045 / 52400049
Remove power cable (3) (coming from blower
unit) from the holder at the handgrip ().
4. Move the handgrip downwards (), so that
the HONDA generator can be installed on
the device.
19 / 29 GB