Device Assembly - physa COLMAR RED Manual De Instrucciones

DEVICE ASSEMBLY

1. Release the safety buckle
2. Put the table on its side and extend the legs to the desired height. To adjust
the height of the table, unscrew the knobs, select the appropriate height by
sliding the side part of the leg, simultaneously moving the knobs to the
selected hole, then screw all knobs. Warning: Make sure the legs are at the
same height.
3. Remove the secured accessories from inside the table.
4. Install the armrests by sliding them into the holes located on the sides of the
backrest.
5. Attach the headrest on the front of the device by sliding it into the appropriate
holes. Hang the front armrest on the headrest holder.