Before First Use - Adler europe AD 4496 Manual De Uso

Contact professional electrician in this matter.
15. If the device is overfilled it may spurt boiling water.
16. WARNING: Do not open the lid if the water is boiling.
17. CAUTION
Risk of burns! The unit becomes hot during use. Only touch the controls
and handles so that you do not burn yourself.
18. Always use caution when boiling water in the device. Do not touch the housing of
device or lid. Do not open the lid during boiling in device or immediately after boiling,
because steam coming out of lid can cause burns.
19. Move the device only by holding it by handle..
20. Do not fill the device above the MAX level or below 4.5l MIN, as this may cause burns
or damage the device
21. Never switch on device without water, as this may cause damage the device
22. Never use device with open cover.
23. Descale your device regularly. Using device with heating element covered by scale
may cause damage.
24. Do not use aggressive detergents to wash the device housing - they can damage the
device or remove the markings.
25. The device is not designed to work with external schedulers or separate remote control
system.
26. Children aged 3 to 8 years old can enable and disable the device only when it is in its
normal position of use, they are supervised or instructed on the safe use and understand
the resulting risks. Children aged 3 to 8 years old cannot connect device, operate, clean or
maintain.
27. Before first use, remove all packaging components. Attention! In the case of a casing
with metal parts, on these elements a slightly visible protective foil can be stretched, which
should also be removed.
28. NEVER cover the device during operation or when it does not cool down completely,
remember that the heating elements of the device take time to cool down completely.
DESCRIPTION:
1:Temperature control knob _ On/Off
2:Target temperature
3:Time remaining
4: Time control knob
5: Current temperature

BEFORE FIRST USE

Before first use, remove all packaging components.
Boil fresh water to remove dust and production residues. Add 6 litres of water and set the thermostat to MAX 100˚C by temperature
control knob (1).
6 :Tap
7:Handles
8: Lid
9:Water tank
10:Rack
4