Tabla de contenido
Publicidad
installation guide
Always use two people when setting up the base, moving or flipping the base.
STEP 1
Place the bed base box in a desired location with the bottom of the box
facing up.
Remove the binding straps and packing materials, making sure not to
puncture the box with any sharp objects.
STEP 2
Remove the bed base from the box keeping the bottom of the base
facing upwards.
STEP 3
To install headboard brackets (sold separately)
see instructions on page 14.
To install the legs, thread the washer over the screw on the leg. Next,
screw the leg into the nutsert on the frame. Do not over tighten.
The legs untwist into separate sections for custom leg height options
(3", 6", 9" or 12")
8
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
STEP 4
To sync two bases with the sync cord - see page 13
Locate the battery backup strap.
Store the battery backup strap in a convenient
location in case of an emergency power outage.
For operating instructions, see page 10.
STEP 5
Uncoil input cord (connected to control box's
power port) and plug into Power Supply.
STEP 6
Uncoil the Power Cord and connect to the
Power Supply. Place Power Supply on the
ground and extend from the base. Ensure that
the Power Supply and all attached cords are
directed toward the desired surge protector.
Publicidad
Tabla de contenido
