Tabla de contenido
Publicidad
installation guide
Always use two people when setting up the base.
STEP 1
Place the bed base box in a desired location with the bottom of
the box facing up.
Remove the binding straps and packing materials, making sure
not to puncture the box with any sharp objects.
STEP 2
Remove the bed base from the box keeping the bottom of the base
facing upwards.
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
6
STEP 3
To install headboard brackets: See detailed installation
instructions on page 10-11.
To install the legs, thread the washer over the bolt of the leg with the
recessed side facing the leg, and tighten by hand. Do not over tighten.
STEP 4
To sync two bases with the SmartSync™ cord - see page 15-16.
Uncoil the Power Down Box from the frame
and install (2) 9 Volt batteries- not included.
Place box on the ground. Ensure that it is
easily accessible when the base is turned to
its upright position.
installation guide
STEP 5
Uncoil input cord (connected to control box's
power port) and plug into Power Supply.
STEP 6
Uncoil the Power Cord and connect to the
Power Supply. Place Power Supply on the
ground and extend from the base. Ensure that
the Power Supply and all attached cords are
directed toward the desired surge protector.
STEP 7
Carefully flip the base over on to its legs. Important: Two people are
required to move the bed base. Do not drag across the floor. Do not
rest frame on its side, excessive pressure may damage the legs.
STEP 8
Plug the base into a power source. A surge protector is strongly
recommended.
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
STEP 9
Ensure batteries are correctly installed in the back of the remote.
Quickly test functions to verify proper setup before placing mattress on
base. Press FLAT to return the base to a flat position.
STEP 10
Connect the mattress to the ZipFit
®
System*.
*If the mattress is not equipped with
the ZipFit
®
System:
Slide the left side of the mattress
retainer bar into the bracket. Pull the
retainer bar to the opposite bracket
and secure the right side.
Basic setup is now complete! See page 8-9 for remote control
operating instructions.
7
Publicidad
Tabla de contenido
