Assembly - Blumfeldt Isaris Manual De Instrucciones

ASSEMBLY

• Keep these operating instructions for future reference.
• If you have already opened the box and removed all packaging, ignore
steps 1 and 2. Go directly to step 3.
Step 1
1. Open the box and remove all the components. Make sure that everything
is included in the scope of delivery.
2. Remove the box and make sure that no accessories remain in the box.
3. Remove all the packaging material except for the honeycomb paper
surrounding the fire bowl.
Step 2
1. Place the fire bowl upside down on a level surface.
2. Remove all the honeycomb paper that is wrapped around the fire bowl.
Step 3
1. Check all components before operating the appliance. Before assembly,
make sure that the gas cylinder valve is in the "OFF" position (see figure A
on the next page).
2. Remove the plastic film from the battery. Unscrew the rubber cap of the
electric igniter and insert the AA battery into the battery compartment.
Make sure the positive (+) terminal is facing the rubber cap. Screw the
rubber cap firmly back onto the battery compartment (see figure B).
3. Place the lava stones in the centre on the top of the fire bowl (see figure C).
4. Do not cover the ignition screen when placing the lava stones in the fire
bowl. Always make sure that the ignition screen is visible. Connect the gas
pressure regulator to the gas bottle (see figure D).

Turn the gas bottle valve clockwise to close the gas supply on the gas
bottle.

Turn the gas pressure regulator coupling clockwise by hand only. Make
sure it is securely fitted.
EN
37