Troubleshooting - Dometic WAECO MagicWatch MWE910 Instrucciones De Montaje Y De Uso

Troubleshooting

As soon as there is an obstacle within the detection range, a repeated signal
tone is emitted.
As you approach, the tone sequence changes, depending on the zone in
which the obstacle is, thus indicating the distance (fig. e).
NOTICE!
A
Stop the vehicle immediately and investigate the situation (getting
out if necessary), if the following happens while you are manoeu-
vring:
when manoeuvring, the device first indicates an obstacle and the
tone sequence speeds up normally (e.g. from slow to medium).
Suddenly the signal tone slows down, or no obstacle is indicated at
all.
This means that the original obstacle is in the blind spot of the sen-
sors (construction-related characteristic), and it is possible to hit it.
11 Troubleshooting
The device indicates no function.
The voltage supply cable (black/blue and brown wires) is not connected or is
incorrectly connected.
➤ Check the connections.
The plugs for the sensors are not connected or are not properly plugged into
the control electronics.
➤ Check the plugs, and make sure they lock into place.
A long tone sounds (approx. 3 seconds) after switching on the ignition
One or more sensors are defective or no longer connected to the control
electronics. The control electronics display shows the defective sensor:
 for example E1 for the front sensor with short cable or E4 for the front
sensor with long cable.
➤ Check the plugs and make sure they lock into place.
➤ Replace the defective sensor(s).
30
All manuals and user guides at all-guides.com
MagicWatch MWE910, 900, 900F
EN