Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Minimum Gauge for Extension Cords (AWG)
(when using 120 V only)
Amp Rating
Total Length of Cord in Feet (meters)
Not
More
25' (7.6
More
Than
m)
Than
0
6
18
6
10
18
10
12
16
12
16
14
Keep the extension cord clear of the working area. Position
the cord so that it will not get caught on lumber, tools, or
other obstructions while you are working with a work light .
Failure to do so can result in serious personal injury.
Check extension cords before each use. If damaged replace
immediately. Never use the work light with a damaged cord
since touching the damaged area could cause electrical shock
resulting in serious injury.
2.4
POWER TOOL USE AND CARE
•
If operating a work light in a damp location is
unavoidable, then the work light should only be
connected to a circuit that is protected by a ground-fault
circuit-interrupter (GFCI). Use of a GFCI reduces the risk
of electric shock.
•
Store work light indoors when not in use.
•
Keep out of reach of children.
•
Do not clean this work light with a water spray or the
like. Follow manufacturers cleaning instructions.
•
Avoid direct eye exposure. Do not direct the light beam at
persons or animals and do not stare into the light beam
yourself (not even from a distance). The work light can
cause flash blindness.
•
Do not use the work light in road traffic. The cordless
work light is not approved for illumination in road traffic.
•
The lens gets very hot during use. To reduce the risk of
burns, do not touch hot lens. Only use power extension
cord set with NEMA 5-15R receptacle and NEMA 5-15P
plug.
2.5
BATTERY TOOL USE AND CARE
•
Disconnect the battery pack from the work light before
making any adjustments, changing accessories, or storing
power tools, etc.
English
150'
50' (15
100' (30
(45m)
m)
m)
16
16
14
16
14
12
16
14
12
Not Recommen-
12
ded
•
Do not permit children to use the work light; it is not a
toy. Children can unintentionally blind themselves or
other persons.
•
Recharge only with the battery charger specified by the
manufacturer. A battery charger that is suitable for one
type of battery pack may create a risk of fire when used
with another battery pack.
•
Use only with specifically designated battery packs. Use
of any other battery packs may create a risk of injury and
fire.
•
When battery pack is not in use, keep it away from other
metal objects like paper clips, coins, keys, nails, screws,
or other small metal objects, that can make a connection
from one terminal to another. Shorting the battery
terminals together may cause burns or a fire.
•
The battery can be damaged by pointed objects such as
nails or screwdrivers or by force applied externally. An
internal short circuit can occur and the battery can burn,
smoke, explode or overheat.
•
Under abusive conditions, liquid may be ejected from the
battery; avoid contact. If contact accidentally occurs,
flush with water. If liquid contacts eyes, additionally seek
medical help. Liquid ejected from the battery may cause
irritation or burns.
•
Battery disposal should be in compliance with the local
regulations that address the disposal of hazardous
materials. Do not incinerate battery pack.
2.6
SERVICE
•
Have your work light serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the work light is maintained.
•
Never service damaged battery packs. Service of
battery packs should only be performed by the
manufacturer or authorized service providers.
3
SYMBOLS ON THE PRODUCT
Some of the following symbols may be used on this work
light. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the
tool better and safer.
Symbol
Explanation
V
Voltage
A
Current
Hz
Frequency (cycles per second)
Wh
Energy Storage Capacity
Ah
Current Capacity
Lm
Lumen
Alternating Current
Direct current
5
EN
Publicidad
Tabla de contenido
