Install The Light Head; Remove The Light Head; Operation; Start The Work Light - GreenWorks Pro WL60A00 Manual Del Operador

EN
8.4

INSTALL THE LIGHT HEAD

• Battery tools are always in operating condition.
Therefore, always turn off the light when the light is not
in use or when carrying the work light at your side.
1. Align the bolt the the hole (on the bracket).
2. Insert the bolt into the hole until it kocks into place and
then tighten them with knobs.
3. Do the same operation on the other side.
8.5

REMOVE THE LIGHT HEAD

1. Unlock the right and left knobs.
2. Remove the bolts.
9

OPERATION

Do not use any attachments or accessories not
recommended by the manufacturer of this work light.
WARNING
WARNING
English
9.1

START THE WORK LIGHT

1. Install the battery pack or connect the power source.
2. Press the ON/OFF switch to turn the work light on. The
work light will be turned on at maximum brightness.
3. To reduce the brightness, press the ON/OFF switch again.
Low voltage operation
When the battery pack is less than 5%, the work light will
flash three times with a brightness of 500 lumens.
• Do not continue to press the ON/OFF switch after the
work light has automatically switched off. The battery
can be damaged.
9.2

STOP THE WORK LIGHT

1. Press the ON/OFF switch to turn the work light off.
8
WARNING