Philips NORELCO QP2515 Manual De Instrucciones página 4

- Use the blade on a clean face. The
blades go blunt faster if on skin that isn't
clean.
- Do not use the blade when damaged or
broken. Replace the blade immediately if
it is damaged.
This product is not intended for shaving,
edging or trimming hairs on lower body
parts or scalp hair.
Switching the product on and off
1 To switch on the product, turn the setting
indicator to the 'on' indication' (I) (Fig. 4).
2 To switch off the product, turn the setting
indicator to the 'off' indication' (O).
Shaving
Warning: Before you use the product,
always check the blade for damage or
wear. If the blade is damaged or worn, do
not use the product, as injury may occur.
Replace a damaged blade before use (see
'Replacement').
Shaving tips and tricks
- Make sure that the blade is in full contact
with the skin by placing it flat on the skin
(Fig. 5).
- For the best result, move the product
against the grain (Fig. 6).
- Make long strokes while pressing lightly.
- You can use the product dry or wet with
gel or foam. You can even use the
product in the shower.
- Shaving a clean beard and face gives the
best results.
Edging
- Use both edges of the blade to create
sharp lines and perfect edges.
- Hold the product in such a way that the
blade is perpendicular to the skin and
one of its edges touches the skin. This
allows more precise detailing of
sideburns and the area around the
mouth and nose.
1 To create sharp edges and lines, you can
use either edge of the blade (Fig. 7).
2 Switch on the product.
3 Place the edge of the blade
perpendicular onto the skin (Fig. 8).
4 Make straight strokes while applying
gentle pressure (Fig. 9).
5 Switch off and clean the product after
each use (see 'Cleaning').
Cleaning
Clean the product after every use.
Never use scouring pads, abrasive cleaning
agents or aggressive liquids such as
gasoline or acetone to clean the product.
Do not tap the product or blade against a
surface to remove hairs and water as this
may cause damage to the product and
blade (Fig. 10). If the blade is damaged,
replace immediately.
Never dry the blade with a towel or tissue,
as this may cause damage.
Cleaning the product
1 Switch the product off.
2 Pull the comb off the blade.
3 Blow off any hairs that have accumulated
on the blade and/or combs (Fig. 11).
4 Switch on the product for approx. 15
seconds while rinsing the blade with
lukewarm water (Fig. 12).
5 Rinse the combs for approx. 15 seconds
with lukewarm water.
6 Carefully shake off excess water and let
all parts air dry completely.
Note: The blade is fragile. Handle it
carefully. Replace the blade immediately if
it is damaged.
Storage
Always attach the protective cap on the
blade to protect the blade from damage
during traveling or storage.
Make sure the product and attachments are
completely dry before you store them for
the next use.
1 Place the protective cap onto the edge
of the blade (Fig. 13).
2 Close the protective cap (Fig. 14).