Descargar Imprimir esta página

Spectroline NANO 365 Serie Manual De Instrucciones

Publicidad

Enlaces rápidos

1.800.544.2843
English
NANO 365 SERIES UV-A LED LAMP INSPECTION KIT
Part No. IDX-200
INTRODUCTION
The Nano 365 Series IDX-200 Rechargeable UV-A LED Flashlight kit contains
the
IDX-200
flashlight,
light
source
featuring
one
ideal
for
industrial
leak
detection
UV light emitted from this product. Avoid eye and skin exposure
to unshielded products
FOR PROFESSIONAL EXAMINATION USE ONLY
IMPORTANT SAFETY INSTRUCTIONS (Read all instructions)
•Do
not
operate
the
Nano
flashlight
(IDX-200)
if
it
•Do not look directly into the light. ALWAYS wear the provided UV-absorbing
protective glasses when operating the flashlight. Use in low-light conditions to achieve
the best inspection results. The darker the room, the greater the fluorescent contrast.
•Use
only
the
provided
•The
IDX-200
is
not
approved
Do not attempt to use it in areas requiring explosion-proof lighting.
•Never
use
this
equipment
these
instructions
because
•NEVER
aim
the
flashlight
being.
It
is
meant
for
professional
•DO NOT attempt to modify the lens assembly or light output. Doing so may alter
the performance and intensity of the IDX-200 and render the item out of compliance.
FEATURES
•Instant on operation, reaches full UV-A intensity immediately.
•Lamp is equipped with antioxidant blacklight filter glass to minimize the visible
light and increase the UV light.
•Anodized aluminum flashlight body to minimize corrosion and maximize years of
heavy use.
•Powered by two AA 1.5 Volt Alkaline batteries.
TECHNICAL SPECIFICATIONS
Length....................................................................................................5.94 (15.1 cm)
Lamp Head Diameter.............................................................................0.89 (2.27 cm)
Weight.................................................................2.8 oz (79.5 grams) (without battery)
Light Source...................................................................................One (1) UV-A LED
Power Requirement...............................................Two AA 1.5 Volt Alkaline Batteries
Continuous Run Time.................................................................................50 minutes
Power Input..............................................................................................0.8~3.2Volts
KIT COMPONENTS
Unpack
and
inspect
the
shipment.
If
any
damage
immediately notify the carrier and supplier, and do not use the light source.
1)Nano 365 Series IDX-200 Flashlight
2)AA Alkaline Batteries (2)
3)Lanyard
5)O-ring (2)
4)Belt Holster
6)Storage Box
www.calcert.com
15
10
20
5
25
0
30
a
portable,
versatile,
ultra-high
intensity
UV-A
and
other
specialized
applications.
WARNING
365
Series
Rechargeable
UV-A
has
been
physically
Ni-MH
battery
for
the
for
use
in
hazardous
atmospheres.
in
any
manner
not
specified
your
protection
may
be
in
the
direction
of
another
fluorescent
inspections
components
for
possible
damage
or
missing
parts
are
lightweight
LED
LED
damaged.
IDX-200.
in
impaired.
human
ONLY!
in
noted,
sales@calcert.com

Publicidad

loading

Resumen de contenidos para Spectroline NANO 365 Serie

  • Página 1 English NANO 365 SERIES UV-A LED LAMP INSPECTION KIT Part No. IDX-200 INTRODUCTION The Nano 365 Series IDX-200 Rechargeable UV-A LED Flashlight kit contains IDX-200 flashlight, portable, versatile, lightweight light source featuring ultra-high intensity UV-A ideal industrial leak detection other specialized applications.
  • Página 2 CHARGING AND USE •The IDX-200 is shipped factory set at the specified intensity for optimal performance during inspections. •Turn flashlight upside down, unscrew remove tail from housing and place included Ni-MH batteries positive end towards head of flashlight. •Replace tail cap by screwing into flashlight housing. •The IDX-200 has one switch (on and off) on rear of tail cap.

Este manual también es adecuado para:

Idx-200