How To Assemble Your Sprayer; Operation - Swissmex Heavy Duty Serie Manual De Operador

3.3.2 How to assemble your sprayer:

Following is explained how to assemble your sprayer, read carefully the text. The number at the beginning of the line corresponds to the
graphic.
1. Take out all the parts from the box and from the tank.
2. Place the sprayer vertically on a table, place the pump holder nut, gasket and felt ring on the side mouth. Oil the piston sleeve and the pump tube, insert
it in the pump tube guide; carefully directing the piston sleeve to avoid any damage.
3. Tighten the pump holder nut. Place the agitator.
4. Place the strainer and the tank lid on the tank opening.
5. Insert the connecting rod in the pump tube placing one flat washer on each side, fix them with the lock pins "C".
6. Pass the pump handle through the base of the tank fixing it to the connecting rod with a flat washer and a lock pin "C" and on the other end with a lock
washer and a cotter pin.
7. Finally tighten the spray gun and tube.
1
289176
SW04
4
6
MODEL 289176 SW04
6
MODEL 289175 SW03
7

OPERATION

4.
Always use the strainer when filling the tank up with liquid.
Mix the solution in a separate container, following the supplier directions on the box.
Pour pre-mixed solution into sprayer and cap.
Place the sprayer on your back and pressurize tank by pumping 25 times approx.
You will need to pump once each 3 or 4 seconds to maintain the desired spraying pressure.
For a continuous spraying, fix the shut-off valve lever with the lever lock.
Move the nozzle cap to change the spraying pattern.
The use of agrochemicals is dangerous, it should be operated with care.
289176
2
SW04
289175
SW03
5
289175
SW03 289176
SW04
289175
SW03
3
289176
SW04
289175
SW03
NOTE:
To ensure good performance use original
"SWISSMEX-RAPID" spare parts.
3