Commands - sylvac Hi Cal 300 Manual De Instrucciones

Commands

Most of the Hi_Cal functions can be controlled by a computer
or a PLC by sending ASCII commands.
As a rule, the format of these commands consists of the first 3 letters of the
corresponding command. Commands can be in upper or lower case, with or
without spaces.
Sending the command <?> corresponds to a data request.
Important: all commands must be followed by a CR (Carriage Return)
Command
?
A
AOFF0/1/ ?
B
BAT ?
BT0/1
BTRST
C
CEN?
CFGSEP0/1/ ?
CLE
D
DEL
DIA
DIA?
DIF?
E
EXT0-10
18
Correspond to
Auto OFF
BlueTooth
CLEar
DELta
DIAmeter
EXTernal contact
Function
Send the displayed DIA and
CEN value in diameter mode
Automatic switch-off deac-
tivated (SBY00) / Activated
(SBYxx) / Polling
Battery status (BAT1 = OK,
BAT0 = low battery)
Bluetooth
module disabled
®
/ enabled
Resetting Bluetooth pairing
®
Request for printout of the
Center's value
DIACEN value separator
deactivated (CR) / activated
(;) / enquiry
Resets the minimum and
maximum registers
Delta mode (maximum -
minimum)
Diameter mode
Diameter value print request
Sending the difference between
the last 2 measurements
See « Button FCT »