Creality Ender-5 Plus Manual Del Usuario página 26

Frame Assembly Pt. 4
Hot Bed
Filament Holder
8pcs
M4X10
M5X8
Make sure the front of the base(b) is facing you. Place the hot bed on the support plate of the double Z-axis frame and align with the
Step 1.
profile holes on it.
Using 8 M4x10 screws, connect the hot bed to the support plate on the Z-axis frame. Make sure the hot bed is flat and all six
Step 2.
screws are securely fastened.
Subsequently, pass the M5x8 socket head cap screw through the threaded hole on the of the metal plate filament bracket , then pass
Step 3.
the M5 T-nut and gently turn the M5 T-nut. Do not �ghten. Rotate the M5 T-nut that has been installed on the metal plate filament
bracket into a posi�on parallel to the groove of the aluminum profile, and insert it into the aluminum profile. The M5 T-nut below the
metal plate filament bracket is parallel to the groove of the 2040 aluminum profile and is inserted into it. The upper M5 T-nut on the
metal plate filament bracket is parallel to the 2040 aluminum profile and inlaid, then �ghten the screw with a n Allen key and �ghten
the M5 T-nut to a posi�on perpendicular to the groove of the aluminum profile.
24
2pcs
M5 T-nut
1