Creality Ender-5 Plus Manual Del Usuario página 29

Loading Filament
1. Preheat
Method 1
Method 2
2. Feeding
Press and hold the extruder lever and insert
the 1.75mm filament through the filament
detector and through the extruder motor. Con-
tinue feeding until you see filament extrude
from the nozzle.
Tip: How to replace the Filament ？
1、Cutting filament near the Extruder and slowly feed new
filament until they are fed into the new filament.
2、Preheating the nozzle and withdraw the filament quickly
and feed the new filament.
27