Reversing Doors - IO Mabe IWO19JSPFSS Instructivo Y Advertencias

INSTALLATION
INSTRUCTIONS
For more information, refer to the User Manual or contact your nearest Authorized Distributor.
IMPORTANT NOTES
When reversing Doors:
• Read the instructions all the way through before
starting.
• Logo badge and handles are included inside the
refrigerator.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Provide a non-scratching work surface for the doors.
IMPORTANT: Once you begin, do not move the
cabinet until door reversal is completed.
These instructions are for changing the hinges from the
right side to the opposite side. If you ever want to change
the hinges back to the right side, follow these same
instructions and reverse all references to left and right.
CAUTION
Lifting Hazard. Single person lift could cause injury.
Use assistance when handling, moving or lifting the
refrigerator doors.
Note: When removing door, to prevent damage to
door and electronics, carefully place the door in a
proper location.
Note: The lower door hinge pin and hinge are keyed
and must be matched correctly for the door to self
close properly. Please follow the directions carefully.
Freezer door is heavy, use both hands to secure the
door before lifting.
WARNING
To eliminate the risk of
electric shock or injury
during installation,
must first unplug the refrig-
erator before proceeding.
Failure to follow these
instructions can result in
electrical shock.
* Picture for reference only
TOOLS YOU WILL NEED
5/16" (7.9mm)
Socket Ratchet/ Driver
Phillips Screwdriver
16
*
you
Thin-blade Screwdriver
Torx T-20 (3.9mm)
Driver
1/4" (6.4mm) Allen
Adhesive Tape
Wrench or Screwdriver

Reversing Doors

1 REMOVE THE REFRIGERATOR
DOOR
1.1 Tape the door
shut with
adhesive tape.
1.2 Remove right and left hinges cover on top the
refrigerator using a Phillips screwdriver.
1.3 Using a 5/16" (7.9mm) Socket ratcher/driver,
remove the bolts securing the top hinge to the
cabinet. Then lift the hinge straight up to free the
hinge pin from the socket in the top of the door.
1.2
COVERS HINGE
1.4 Remove the tape and tilt the door away from the
cabinet. Lift the door off the center hinge pin.
1.5 Set the door on a non-scratching surface with the
inside up.
1.3
TOP HINGE