IO Mabe IWO19JSPFSS Instructivo Y Advertencias página 18

5.2 Insert the top pin hinge
inside the hole in the door.
Make sure the door is
aligned with the cabinet
in the opposite side from
the hinge. Attach the hinge
to the top of the cabinet
loosely with the bolts.
Make sure the gasket on
the door is flush against the
cabinet and is not folded.
Support the door on the
handle side and make sure
the door is straight and gap
between the doors is even
across the front. While
holding the door in place,
tighten the screws
60lbs-in (6.78Nm).
6 INSTALL THE LEFT HINGE
COVER
6.1 Locate the left hinge
cover that comes
with the kit.
6.2 Using a Phillips
screwdriver install the
screws with the hinge
cover.
7
INSTALL THE LEFT HINGE
COVER
7.1 Remove the front insert from the left hinge
cover.
7.2 Using a Phillips screwdriver install the screws
with the hinge cover.
7.1
18
to
7.2
8 INSTALL THE RIGHT HINGE
COVER
8.1 Insert the front insert in the right hinge cover.
8.2 Using a Phillips screwdriver install the screws
with the hinge cover.
Note: For models with freezer door, locate the front
insert that comes with the kit.
8.1
9
TRANSFER THE FRONT COMPO-
NENTS ON THE REFRIGERATOR
DOOR
9.1 Using a Phillips
screwdriver
remove the
screws holding
the plastic part
shown below
from the left side
and install them
on the opposite
side.
Note: Refer the HANDLE INSTRUCTIONS for remove
and attach the handles.
10 INSTALL THE LOGO BADGE
10.1 Locate the new logo badge from the kit,
remove the adhesive backing paper and align
vertically badge center to hole center and
horizontally 2.5" (63.5mm) from the door side
edge. Apply pressure to the badge to ensure it
sticks to the door. Same for opposite side.
10.2 Locate the plug button from the kit and install
it in the opposite side of handle
10.1
2.5"
(63.5mm)
8.2
.
10.2