Sanyo VCC-P6784 Manual De Instrucciones página 16

L5BY2_US(VCC-P6784)(GB_FR_ES).book 15 ページ ２００７年１２月７日 金曜日 午後３時３９分
Naming Cameras <OPTION> - <TITLE>
4
3
Repeat step to complete the name and select
[ID].
Example: ROOM1
TITLE SETTING
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
0123456789 :-v
·ID ROOM1???????????
x
• The letters "???...." do not appear on the monitoring screen, but
if you select "ON" for [TITLE] and then enter no letter at all, the
monitor will show you "???....".
MEMO: If you want the name to be displayed on the monitor in two lines,
insert the line feed mark (v) in the "ID string" wherever you want to
start a new line. On the monitor screen, the name will be displayed
in two lines. You can enter up to 16 characters including the line
feed mark (v).
5
Select [POSITION] – "SET" and press the SET
button.
ID ROOM1???????????
x
· POSITION SET
PRESET OFF
MENU
BACK
ROn the normal monitoring screen, the name will be displayed.
15
GB
All manuals and user guides at all-guides.com
ID string
y
6
Determine the display position of the name using
the Selection buttons and then press the SET
button.
ROOM1
RReturns to the settings screen.
■ To delete the name specified:
Set [PRESET] to "ON", and press the SET button.
R All the characters will be replaced with "?".
• If an alarm signal is input, the camera name on the screen will
Note:
blink during the time that has been set in [DURATION] (see page
26). When the camera name is not specified, "???...." will blink.
• When masking setting is "ON", the camera name will not be
displayed.