Installation And Setting - Meister basic BHKS 1200 LB LASER Traducción De Las Instrucciones De Servicio Originales

5403630-Handkreiss-man_a 02.12.11 12:56 Seite 65
reflective materials. There is a risk of
reflected light here.
• Repairs to the laser projector may
only be carried out by specialists.
• Do not insert solid objects into the
laser optic (14).
• Clean the laser optic with a soft, dry
brush.
7 – Installation and setting
Parallel cutting
Fig. 2
9
1. Undo the adjustment screw (c).
2. Adjust the parallel stopper (9) according
to the scale, pay attention to the width
of the saw blade
CAUTION! Make a test cut using
a piece of waste wood.
Notch A – vertical cut 90°
Notch B – angled cut 45°
All manuals and user guides at all-guides.com
c
45° B
A
90°
Setting the cutting depth
1. Undo the adjustment screw (b).
2. Swing the saw shoe downwards.
3. Loosen the clamp lever (c).
4. Set the cutting depth using the scale.
Tooth tips must reach approximately
2 mm out of the wood. Tighten the
clamp lever up again.
Adjusting the saw shoe (angled cut)
1. Undo the adjustment screw (11).
2. Set the shoe to the required number
of degrees 0 – 45°.
3. Tighten the adjustment screw.
Fig. 3
c
b
Fig. 4
11
45°
B
65