Operation; Mode Of Operation - Meister basic BHKS 1200 LB LASER Traducción De Las Instrucciones De Servicio Originales

5403630-Handkreiss-man_a 02.12.11 12:56 Seite 66
Setting the splitting wedge
Fig. 5
3
4
3 mm
1. Undo the adjustment screw (b/Fig. 3).
2. Swing the saw shoe downwards.
3. Undo the screws.
4. Set the splitting wedge and tighten
the screws again.
Changing the saw blade
Fig. 6
1. Open the pendulum protective cover
and hold firmly.
2. Hold the flange (8) with the flange
wrench.
3. Undo the hexagonal screw (6) with
the pin wrench.
4. Remove flange and blade by pulling
downwards.
5. Clean the flange, insert a new blade.
66
Pay attention to the direction the
All manuals and user guides at all-guides.com
4
6
8
blade runs in (see the arrow on the
protective cover).
6. Tighten the hexagonal screw, ensure
device is running correctly.
7. Set the splitting wedge.
8 – Operation
Switching on and off
Fig. 7
The machine has a two button security
switch mechanism: The machine can
only be put into operation if the handle
is held firmly and both buttons are
pressed. When the handle is released,
the machine switches off automatically
to ensure that accidental operation is
not possible.
9 – Mode of operation
• The pendulum cover is automatically
pushed back by the work piece.
• Gently and evenly push the circular
saw forwards.
• The waster piece should be located
on the right-hand side of the circular
saw to ensure that the largest piece is
lying fully on the table.
2